Updated 200-301 VCE ensures success

Journey into the vast realms of certification, fortified by the academic lighthouse that is the 200-301 dumps. As diverse as the constellation in the night sky, the 200-301 dumps bring forth an illustrious set of practice questions, guiding your path through the celestial knowledge maze. Whether the mesmerizing tales from PDFs pull you into their orbit, or the VCE format\’s dynamic simulations transport you to another galaxy, the 200-301 dumps promise a cosmic experience. A celestial guide, the 200-301 dumps decode nebulous concepts, ensuring you sail smoothly through the astral challenges. With stars in our eyes, we proudly proclaim our 100% Pass Guarantee.

[Now Available] Enhance your exam mastery with our latest 200-301 PDF and Exam Questions, committing to 100% success

Question 1:

How do TCP and UDP fit into a query-response model?

A. TCP establishes a connection prior to sending data, and UDP sends immediately.

B. TCP uses error detection for packets, and UDP uses error recovery.

C. TCP avoids using sequencing, and UDP avoids using acknowledgments.

D. TCP encourages out-of-order packet delivery, and UDP prevents re-ordering.

Correct Answer: A

Question 2:

Refer to the exhibit.

A network engineer is configuring a wireless LAN with Web Passthrough Layer 3 Web Policy. Which action must the engineer take to complete the configuration?

A. Set the Layer 2 Security to 802.1X.

B. Enable TKIP and CCMP256 WPA2 Encryption.

C. Enable the WPA Policy.

D. Set the Layer 2 Security to None.

Correct Answer: D

Navigate to WLAN > Edit > Security > Layer2, and select None for Layer 2 Security:

https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/116879-configure-wlc-00.html

Question 3:

Refer to the exhibit. Which two prefixes are included in this routing table entry? (Choose two.)

A. 192.168.1.17

B. 192.168.1.61

C. 192.168.1.64

D. 192.168.1.127

E. 192.168.1.254

Correct Answer: AB

Question 4:

You have two paths for the 10.10.10.0 network – one that has a feasible distance of 3072 and the other of 6144. What do you need to do to load balance your EIGRP routes?

A. Change the maximum paths to 2

B. Change the configuration so they both have the same feasible distance

C. Change the variance for the path that has a feasible distance of 3072 to 2

D. Change the IP addresses so both paths have the same source IP address

Correct Answer: BC

Every routing protocol supports equal cost path load balancing. In addition, Interior Gateway Routing Protocol (IGRP) and EIGRP also support unequal cost path load balancing. Use the variance n command in order to instruct the router to include routes with a metric of less than n times the minimum metric route for that destination. The variable n can take a value between 1 and 128. The default is 1, which means equal cost load balancing. Traffic is also distributed among the links with unequal costs, proportionately, with respect to the metric. Reference: https://www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routing-protocol-eigrp/13677-19.html#topic1

Question 5:

What are two characteristics of a public cloud Implementation? (Choose two.)

A. It is owned and maintained by one party, but it is shared among multiple organizations.

B. It enables an organization to fully customize how It deploys network resources.

C. It provides services that are accessed over the Internet.

D. It Is a data center on the public Internet that maintains cloud services for only one company.

E. It supports network resources from a centralized third-party provider and privately-owned virtual resources

Correct Answer: CE

Question 6:

What is the primary function of a Layer 3 device?

A. to analyze traffic and drop unauthorized traffic from the Internet

B. to transmit wireless traffic between hosts

C. to pass traffic between different networks

D. forward traffic within the same broadcast domain

Correct Answer: C

The primary function of a Layer 3 device is to pass traffic between different networks.

Question 7:

Which MAC address is recognized as a VRRP virtual address?

A. 0000.5E00.010a

B. 0005.3709.8968

C. 0000.0C07.AC99

D. 0007.C070.AB01

Correct Answer: A

0000.5E00.01xx is VRRP virtual MAC (Ans. A with xx=0A group)

0000.0c07.acxx is HSRP virtual MAC address (Ans. C with xx=99)

0007.b400.xxyy is GLBP virtual MAC (Not in the answers), xx is group and yy is AVF

Question 8:

Refer to the exhibit.

Router R1 is added to the network and configured with the 10.0.0.64/26 and 10.0.20.0/26 subnets. However, traffic destined for the LAN on R3 is not accessible. Which command when executed on R1 defines a static route to reach the R3 LAN?

A. ip route 10.0.0.64 255.255.255.192 10.0.20.3

B. ip route 10.0.15.0 255.255.255.0 10.0.20.1

C. ip route 10.0.15.0 255.255.255.192 10.0.20.1

D. ip route 10.0.15.0 255.255.255.0 10.0.20.3

Correct Answer: D

We need to specify the destination network (10.0.15.0/24) and the next hop IP of the router to get to that network (10.0.20.3).

Question 9:

DRAG DROP

Drag and drop the statement about networking from the left into the Corresponding networking types on the right. Not all statements are used.

Select and Place:

Correct Answer:

Controller-based Networking :

-The type deploys a consistent configuration across multiple devices.

-Southbound APIs are used to apply configurations.

Traditional Networking :

-A distributed control plane is needed.

-This type requires a distributed management plane.

On a SND network the control plane is centralized on the the SND controller not distributed on the networking devices.

Northbound APIs do not interact with end devices. They allow the SND controller to interact with applications on the application plane.

On a SND network the management plane is not centralized, it is distributed. Network management protocols, such as Telnet, SSH, SNMP, and Syslog operate in the management plane on both traditional network and controller-based

network.

Question 10:

A network engineer is configuring a switch so that it is remotely reachable via SSH. The engineer has already configured the host name on the router. Which additional command must the engineer configure before entering the command to generate the RSA key?

A. password password

B. ip ssh authentication-retries 2

C. ip domain-name domain

D. crypto key generate rsa modulus 1024

Correct Answer: C

https://www.cisco.com/c/en/us/solutions/small-business/resource-center/networking/how-to-setup-network-switch.html

Question 11:

Which WAN topology provides a combination of simplicity quality, and availability?

A. partial mesh

B. full mesh

C. point-to-point

D. hub-and-spoke

Correct Answer: C

Simplicity : Point-to-point communication links require minimal expertise to install and maintain.

Quality : Point-to-point communication links usually offer high quality service, if they have adequate bandwidth. The dedicated capacity removes latency or jitter between the endpoints.

Availability : Constant availability is essential for some applications, such as e-commerce. Point-to-point communication links provide permanent, dedicated capacity which is required for VoIP or Video over IP.

Question 12:

Refer to the exhibit.

A network engineer is updating the configuration on router R1 to connect a new branch office to the company network. R2 has been configured correctly. Which command must the engineer configure so that devices at the new site communicate with the main office?

A. ip route 172.25.25.1 255.255.255.255 g0/2

B. ip route 172.25.25.0 255.255.255.0 192.168.2.2

C. ip route 172.25.25.0 255.255.255.0 192.168.2.1

D. ip route 172.25.25.1 255.255.255.255 g0/1

Correct Answer: B

Question 13:

An engineer must configure a/30 subnet between two routers. Which usable IP address and subnet mask combination meets this criteria?

A. interface e0/0

description to HQ-A371:19452 ip address 209.165.201.2 255.255.255.252

B. interface e0/0 description to HQ-A371:19452 ip address 10.2.1.3 255.255.255.252

C. interface e0/0 description to HQ-A371:19452 ip address 172.16.1.4 255.255.255.248

D. interface e0/0 description to HQ-A371:19452 ip address 192.168.1.1 255.255.255.248

Correct Answer: A

Question 14:

A Cisco engineer at a new branch office is configuring a wireless network with access points that connect to a controller that is based at corporate headquarters Wireless client traffic must terminate at the branch office and access-point survivability is required in the event of a WAN outage.

Which access point mode must be selected?

A. Lightweight with local switching disabled

B. Local with AP fallback enabled

C. OfficeExtend with high availability disabled

D. FlexConnect with local switching enabled

Correct Answer: D

Question 15:

How do TCP and UDP differ in the way they provide reliability for delivery of packets?

A. TCP does not guarantee delivery or error checking to ensure that there is no corruption of data, UDP provides message acknowledgement and retransmits data if lost.

B. TCP provides flow control to avoid overwhelming a receiver by sending too many packets at once, UDP sends packets to the receiver in a continuous stream without checking for sequencing

C. TCP is a connectionless protocol that does not provide reliable delivery of data; UDP is a connection-oriented protocol that uses sequencing to provide reliable delivery.

D. TCP uses windowing to deliver packets reliably; UDP provides reliable message transfer between hosts by establishing a three-way handshake.

Correct Answer: B

Ref: CCNA 200-301 Official Cert Guide, Volume 2

“Chapter 1. Introduction to TCP/IP Transport and Applications …

Flow Control Using Windowing

TCP implements flow control by using a window concept that is applied to the amount of data that can be outstanding and awaiting acknowledgment at any one point in time. … User Datagram Protocol

UDP provides a service for applications to exchange messages. Unlike TCP, UDP is connectionless and provides no reliability, no windowing, no reordering of the received data, and no segmentation of large chunks of data into the right size

for transmission.

…”